They say prevention is better than cure, which is why Santam’s Risk Management team put together these handy tips for you to check when maintaining your geyser:

  • Insulate your geyser with a geyser blanket. This prevents heat loss, reducing the cost of electricity needed to keep water hot.
  • Turn down your geyser temperature to 60 degrees Celsius. This will save some money on your electricity bill.
  • Check that the electrical isolator switch is within 1 meter of the geyser. This was not a requirement on old geysers. The geyser also has to be earthed.
  • Check that you have a drip tray and that it can safely drain away any leaks from a burst geyser. This will save you a lot of discomfort from having to claim for and replace mouldy carpets or cupboards.
  • Fix leaking geysers which would be dripping water outside through a pipe from the drip tray that is under your geyser.  A steady drips wastes a lot of water but also means your geyser will need to continuously heat more water which adds to your monthly water and electricity bills.
  • There should be a cover over the thermostat and element. These are often just left lying next to the geyser.
  • Maintain your geyser by replacing the self-sacrificing anode. Anode rods come installed with geysers and are generally made of magnesium or aluminium which are screwed into the inside of the geyser. This anode, or rod, prevents corrosion of the geyser by “self-sacrificing” its metal which attracts the corrosion of the water and its minerals preventing rust. When there’s no sacrificial metal left on the anode, the tank can rust out but generally last about five years. This depends on the water quality and usage. Therefore you can save money by maintaining your geyser with a replacement anode.
  • Check that you have the appropriate plumbing piping. The geyser may be fed with a plastic pipe, up to the shut off valve, but the pipe into and out of the geyser must be copper or galvanised steel.